TurboConnect Software Update Instructions
Verifying TurboConnect software version is up to date
Step 1: Power on the device and wait until the device is fully booted (This will take a few minutes). The device is fully booted when the LED indicator switches from trailing white (booting) to solid blue (idle)
Step 2: Once fully booted, the charger’s Wi-Fi access point will be visible and be displayed as the serial number.
Using a laptop/desktop, connect to this access point using the Wi-Fi password found in the manual as shown below:
a. Wi-Fi password found in manual
Note: This password is unique for each charger
b. Connecting to the access point
Step 3: Once connected, open a web browser (such as Google Chrome, Microsoft Edge, etc) and go to https://172.20.0.1 to access the device’s web UI
Step 4: Login to the Web UI using the following credentials:
a. Username: admin
b. Password: Found in the manual as Master Password (Unique per device)
Step 5: Once successfully authenticated, you will land on the home page of the Web UI.
Navigate to the “System” tab, then scroll down to the Software Information section. If the Comboard SW Version is under 3.2.2, please visit the link below to download the updated software version: Software Download
Then continue with the following steps to update the TurboConnect.
Step 6: In the same page, navigate to Firmware Update and select the file downloaded from the above link
Step 7: Once the file has been selected, the update will begin.
When the update is complete, the system will reboot. (The update will take a few minutes)
Step 8: Wait until the update is complete, the system has rebooted, and the Wi-Fi access point is visible again
Step 9: Log back into the Web UI and verify the software version has been updated
All set!
